SOF AvFID Operations and Maintenance Facilities

IMEG provided structural, mechanical, electrical, plumbing, and communications design services for new and renovated facilities for the Special Operations Forces Aviation Foreign Internal Defense Operations and Maintenance Facilities at Duke Field. Demolition of two facilities was also included in the project scope. The 78,700-sf new two-story 919th Special Operations Wing Facility supports 260 Special Ops

New Powertrain Aircraft Component Repair Shop and Engines Assembly Shop – Phase IV

IMEG provided structural, MEP, and communications engineering design services for B1700.4, the fourth phase of the new Powertrain complex at Corpus Christi Army Depot, TX. The new ACRS Engines Assembly Shop will house the majority of repair and overhaul processes now housed in building 8, a central energy plant II, the second phase of a

HVAC System Replacements

IMEG, under its joint-venture with PRIME AE, provided structural, mechanical, electrical, and plumbing engineering design services to replace the HVAC systems of Islands A, B, and C and meet the needs of the island occupants located inside Hangar 1001 at Kirtland Air Force Base. Constructed in the early 1950s, Hangar 1001 primarily houses and maintains

HVAC System Repair

IMEG, under its joint-venture with PRIME AE, provided field investigation and engineering design services to replace the HVAC system along with the necessary electrical workin dorm Building 20351 at Kirtland AFB, New Mexico. The project scope was to replace all chillers, boilers, pumps, exhaust fans, two-pipe fan coil units, and piping related to the existing

Repair of Plumbing, Domestic, and Chilled/Hot Water Piping

IMEG, working with joint venture firm PRIME AE, provided mechanical, electrical, and plumbing investigation and engineering design services for the evaluation and repair of the piping, including sewer, domestic, and chilled/hot water lines, at Building 27496 and 27497 at Kirtland AFB, New Mexico. Our team provided pre-design planning support, and the preparation of designs including

Training Facility Renovation

IMEG provided design for the renovation of Building 2945(B2945), constructed in 1966-1967 and part of a three- building compound arranged around a central parking lot. All three buildings were originally dormitories but have been converted to other uses. B2945 is a three-story training facility with administrative support areas for staff. The building was previously renovated,

Planning Charrette Report for the Air Force Materiel Command HQ Repair/Renovation

IMEG, working with joint venture firm PRIME AE, provided structural, MEP, and technology communications engineering design services for a complex planning and programming project for the Air Force Materiel Command (AFMC) Headquarters renovation. The project had a demanding 18-week schedule that included weekly deliverables. The goal of the multi-phase project was a recapitalization of the

Dormitory Renovations

IMEG completed a design charrette, programming, concept designs, design analysis, and construction documents for the renovation of two dormitories at Minot Air Force Base. The goal of the project was to bring the buildings into compliance with Dorm 4 Airmen standards of the Air Force Unaccompanied Housing Guide 2006. Both buildings were constructed in the

S241 Building Conversion To New Facility

IMEG provided structural, mechanical, electrical, plumbing, and technology engineering design services for the complete renovation and adaptive reuse of Building S241 to support the new My Navy Career Center. The project included site investigations, engineering studies, full design plans and specifications, construction cost estimates, and associated engineering services. The new contact center will accommodate 579

Powertrain Complex New Aircraft Component Repair Shop – Phase III

IMEG provided structural, mechanical, electrical, plumbing, and communications engineering design services for Phase III of the new Powertrain complex at Corpus Christi Army Depot, the only depot-level aviation facility for repair and overhaul of rotary wing aircraft (helicopters) engines and components in Army Aviation. Phase III included the Machining Facility of the Aircraft Component Repair